Adult Male Circumcision Trainer Kit simulates the morphology of a penis with phimosis and is specifically designed for circumcision training. It enables practitioners to perform the three most common circumcision methods, Forceps guided method, Dorsal slit method, Sleeve resection method. It is intended for use by healthcare professionals practicing the necessary skills for both prophylactic and therapeutic male circumcision procedures, allowing them to practice various circumcision techniques.

Attach the foreskin to prepare for circumcision practice

Step1: The model is equipped with suction pads on its base to secure the training equipment during use.

Step 2: Apply pressure to firmly press the model onto the work surface.

Step 3: Retrieve one piece of foreskin, one rubber band, and one sachet of lubricant from the packaging.

Step 4: Apply the lubricant generously onto the model.

Step 5: Thoroughly rub the lubricant along both the top and bottom of the penis until fully covered.

Step 6: Gently stretch the foreskin cover the penis.

Step 7: Extend it to cover the entire length of the penis, reaching down to the base.

Step 8: Ensure the end of the foreskin aligns with the base of the penis.

Step 9: Press the opening end of the foreskin firmly onto the penis.

Step 10: Maintain a distance of approximately 5 millimeters between the end of the foreskin and the groove behind the glans of the penis. Adjust if necessary.

Step 11: The elastic band should sit snugly just behind the glans, stretched gently.

Step 12: Lift the penis and cross the elastic band securely.

Step 13: Lower the penis and guide the loop of the elastic band over the top.

Step 14: Repeat this process three times to ensure a secure fit in the groove behind the glans.

Step 15: Now, gently pull the end of the foreskin towards the tip of the penis.

Step 16: Gradually stretch the foreskin, taking care not to pull too hard to avoid detachment.

Step 17: Fold the foreskin back and secure it onto the penis.

Step 18: Guide the folded foreskin back down the shaft of the penis until aligned with the tip.

Step 19: Wipe off any excess lubricant.

Video Guide:

The circumcision model is now ready for use. Follow guide to practice circumcision methods.

After each use, it is essential to thoroughly clean the product to prevent gel residue from remaining on the model, which could affect the next foreskin installation.